Specifications

Little Board/486i Technical Manual
3–2
Page Menu Name Functions
1 Standard (CMOS/EEPROM)
Configuration
Set date and time
Define floppy drives
Define IDE hard disks
Select video type
Display DRAM quantity
Set error halt conditions
Enable/disable video shadow RAM
Set POST display option
2 Options/Peripheral
Configuration
Enable/disable extended BIOS functions
Enable/disable serial ports
Enable/disable parallel port
Enable/disable floppy interface
Enable/disable IDE interface
Enable/disable hot key access to SETUP
Set video display state
Select POST display option
Configure byte-wide sockets
Enable/disable expansion BIOS ROM
Enable/disable serial boot loader
Enable/disable watchdog timer
Configure Ethernet LAN interface
Configure video display
Enable/Disable SCSI terminators
3 Extended SCSI and Hard
Disk configuration
Set SCSI controller parameters
Configure SCSI disk map
Select floppy or hard disk boot
Configure DOS disk map
4 Extended Serial Console
Configuration
Configure serial port parameters for serial
console output
Configure serial port output handshake option
Configure serial port parameters for serial
console input
Delete/include console port from DOS COM
table
* SETUP pages 3 and 4 are available when you enable Extended BIOS from SETUP
Table 3-1 Functions on Each SETUP Page
Note
Some SETUP options can put your system into an unrecoverable
state. For instance, you might set a display option that prevents
you from seeing the SETUP screens. Installing a jumper between
J11-7 and J11-8 (Serial 1 DTR and RI) temporarily defeats the
SETUP parameters stored in the configuration memory so that you
can reenter SETUP and correct the problem.