Specifications

Hardware Configuration
2-9
Note: W4 must be installed during +12V Flash EPROM Programming
Figure 2-6. Byte-wide Socket S0 +12 Volt Flash EPROM Jumpering
Figure 2-7. Byte-wide Socket S0 NOVRAM Jumpering
2.4.2 Custom Jumpering
Tables 2-5 and 2-6 show a summary of the functions for each pin of each jumper array (W1 and
W2). The tables can be used to determine how to jumper the byte-wide socket for devices that are
not shown in the jumpering figures. The tables show which signal appears on each jumper pin and
what pins they connect to on the 32-pin socket.
Note that 32-pin socket pin numbers are given in the tables. To properly interpret numbering for a
28-pin device in socket S0, remember that socket pins 1, 2, 31, and 32 are unused (See Figure 2-2
for details).