User`s manual

Installation Guide 19
3 Installation Guide
3.1 Hardware Installation
Use the following steps to install the GIE62+ series board on the
PCI express bus:
1. Remove the computer cover using the instructions from
the computer manual.
2. Check that there is an empty PCI express slot. If there is
not an empty slot, remove a PCI express board from the
computer to make room for the GIE62+ board and take
note of the chosen slot number.
3. Remove the blank metal plate located at the back of the
selected slot (if any). Keep the removed screw to fasten
the GIE62+ board after installation.
4. Carefully position the GIE62+ in the selected PCI
express slot. If using a tower computer, align the board
with the board slots.
5. Press the board firmly, but carefully into the connector.
6. Anchor the board by replacing the screw.
7. Plug in the cable to the PoE power connector (CN3).
8. Connect device via a Gigabit Ethernet connector.
9. Turn on the computer.
Note: The GIE62+ can be installed in a PCI Express x4, x8, and
x16 slot.