User's Manual

14
InstallingtheEthernetCableFeed‐through
A liquid-tight wire grip is recommended for the Ethernet cable feed-through. The markings on
the bottom of the unit show where to make a hole for the wire grip.
Figure4:Bottomviewofthecommunicationunit
1. Make sure the communication unit is not powered up.
2. Use a drill or punch to create a hole for the wire grip within the marked area.
Notice:
Drillingoutsideofthedesignatedareamaydamageinternalelectronic
components.
Figure5:Drillholeforthewiregripwithinthemarkedarea
Installliquid‐tight
wiregripinthisarea