User Manual And Parts

12
EN
1.1 - UNPACKING
When taking delivery of the slicer, ensure
that the packaging is fully intact; if this is
not the case, please advise the courier or
local dealer immediately.
In order to remove the slicer from the
packaging, please proceed as follows:
• Cut and remove the plastic bands.
• Open the box and take out the
instruction booklet.
• Proceed as described hereafter.
- Remove the protective cardboard
covers from inside the box.
- Lift the machine with great care and
place on a solid surface.
- Remove the plastic bag in which
the slicer is wrapped.
Check that all components spec-
ified in the delivery note and this
instruction booklet are present
and fully intact.
• Should any faults be noted, such as:
- dents to the frame or guards;
- controls that are either not working
or broken;
- missing items or other problems;
please advise the courier, manufacturer
and service centre immediately.
- Carefully dispose of packaging com-
ponents (bands, cardboard, polysty-
rene, polythene bags, etc.) as report-
ed below and in accordance with the
standards of the
di seguito ed in ot-
temperanza alle norme del Country
of use.
PACKING
This product complied with Directive 2002/19/UE.
The crossed out wheeled bin symbol on equipment indicates that it must be treated separately
from household waste at the end of its working life and therefore taken to a recycling facility for
electrical and electronic equipment or handed over to the reseller when purchasing new equipment
of the same type.
The user is responsible for consigning the equipment to appropriate collection facilities at the end
of its working life or face the penalties provided for by current waste management legislation.
Separate collection for subsequent delivery of waste equipment to environmentally-compatible
recycling, treatment and disposal facilities to prevent possible negative impacts on the environment
and human health whilst encouraging recycling of the product’s components.
For further information regarding the available collection facilities, please contact your local refuse
collection service or the shop in which the purchase was made.
Manufacturers and/or importers fulfil their obligations concerning environmentally-compatible
recycling, treatment and disposal either directly or by joining a collective scheme.
GUIDE TO THE TREATMENT OF WASTE EQUIPMENT
13
MADE IN ITALY
F 195 - S 220 - F250 ES
S 220 AF - F 250 E - F 250 I - F 275 E - F 275 I - F 275 IL
F 300 R - F 300 E - F 300 EL - F 300 CL - F 300 I - F 330 I - F 350 I - F 370 I
Istruzioni per l’uso e la manutenzione
Affettatrici a Gravità CE Professionali
IT
Fig. 1
EN
The packing components ( bands , card-
board
, polystyrene , etc.) are products
assimilable to the urban solid refusals.
NAMEPLATES - CONFORMITY MARKINGS
The device described in this manual is
produced in accordance with the directives
in force, as amended. All component parts
are adapted to the requirements of the
Directive and the CE mark testifiying the
compliance.
The plate with the identification of the
manufacturer, the technical machine and
the CE marking is located on the base of
the slicer
(gura 2).
DO NOT DUMP PACKAGING!
DISPOSE OF WASTE
RESPONSIBLY!
☞
The plate must never be re-
moved and must always be
legible.
In case of wear or dama-
ge the user is required to
replace it.