User Manual And Parts

36
180°
Fig. 20
EN
EXECUTION OF THE SHARPENING
9 .2 - Versions with built-in sharpener
WARNING: Cutting hazard! Use protective cut- and tear-
resistant gloves and perform all operations with extreme care.
PAY ATTENTION AT ALL TIMES!
The blade sharpening should be performed periodically, as soon as you feel a decrease
in the ability of cutting blade
, it should follow the instructions below:
1. Carefully clean the blade (11) c
with denatured alcohol to degrease it after
disconnecting the plug from the socket;
2. Loosen the knob (20a), lift and rotate 180° the sharpener (20) and insert the wheels
on the slicer’s blade. Tighten the knob (20a);
20a
20a
20
20
11
20
20
20
11
11
11
37
Fig. 21
Fig. 22
30÷40 sec.
3÷4 sec.
EN
EXECUTION OF THE SHARPENING
3. Trigger the switch (1) and press the little button (x2);
4.
Allow the blade to rotate for about 30 to 40 seconds and then use the switch to stop
it checking with a slight shift (using a pencil) to the outside of the blade if the burr is
formed
.
We reccomend to perform this check very carefully as
the blade is very sharp.
5. Ascertained the formation of the burr, trigger the switch again (1) for 3/4 seconds
pressing the little buttons at the same time (x2 and x3);
☞
DO NOT PROLONG THIS OPERATION BEYOND THE FEW
ABOVEMENTIONED SECONDS TO PREVENT THAT THE
BLADE EDGE WILL TWIST.
x2
x3
x2