User Manual And Parts
38
Fig. 23
EN
EXECUTION OF THE SHARPENING
LUBRICATION
6. After completing sharpening, we
advise cleaning the wheels using a
small brush soaked in alcohol;
7. After the sharpening operation return
the sharpener to its original position.
10.1 - Lubrication of carriage sliding guides and product holder plate
(weekly)
☞
Only use the tted oil; if you don’t have one use vaseline white
oil. DO NOT USE VEGETABLE OIL.
• Apply a few drops of lubricant o the guide rails and slide the assemblies back and
forth 3/4 times;
• Clean where necessary wiping the excess lubricant.
39
Fig. 24
EN
MOTOR BELT TENSION ADJUSTMENT
When after a given time the slicer has an unusual noise because of the belt
(30), proceed as follows:
• Disconnect the plug from the socket.
• Lift the slicer and place it on its side (gure “24”).
☞
Make sure that the slicer is stable and can not
inadvertently fall.
• Unscrew the pins (5).
• Loosen the screw (31) and remove the cover (32).
• Loosen the locknut (33). Turn the tensioner (34) until obtaining the optimal
tension of the belt (30).
• Tighten the locknut (33).
• Replace the cover (32) with the screw (31) and then replace the pins (5).
☞
Do not over-tighten the belt.
In the rotation, the engine could force and the belt
may be damaged.
Only for personnel authorized by the manufacturer
30
32
31
5
33
34
39
Fig. 24
EN
MOTOR BELT TENSION ADJUSTMENT
When after a given time the slicer has an unusual noise because of the belt
(30), proceed as follows:
• Disconnect the plug from the socket.
• Lift the slicer and place it on its side (gure “24”).
☞
Make sure that the slicer is stable and can not
inadvertently fall.
• Unscrew the pins (5).
• Loosen the screw (31) and remove the cover (32).
• Loosen the locknut (33). Turn the tensioner (34) until obtaining the optimal
tension of the belt (30).
• Tighten the locknut (33).
• Replace the cover (32) with the screw (31) and then replace the pins (5).
☞
Do not over-tighten the belt.
In the rotation, the engine could force and the belt
may be damaged.
Only for personnel authorized by the manufacturer
30
32
31
5
33
34