User Manual And Parts

6
EN
GENERAL WARNINGS
• Before plugging the appliance make sure that the data on the label
correspond to those of the electrical distribution network.
• The plate is on the bottom of the appliance.
•
For your safety, it is recommended to power the device through a circuit
breaker (DRC) with trip current not exceeding 30 mA.
• In case of incompatibility between the socket and the plug of the
appliance have the die-cast wire and plug with another one suitable
by an authorized retailer. In case of tampering the manufacturer
doesn’t answer neither for safety, nor for warranty. Alternatively have
the socket replaced with a suitable type by a qualied professional.
The latter, in particular, will also have to ensure that the section of the
socket cables is suitable for the power absorbed by the appliance.
In general it is not advisable to use adapters, multiple sockets and/or
extensions.
• Do not connect the appliance to the electrical power through external
timers or remote operating systems.
• The use of any electrical appliance requires the observance of some
basic rules. in particular:
- do not touch the appliance with wet hands
- do not use the appliance barefoot
- do not pull the power cord or the appliance itself to remove the plug
from the socket
-
do not leave the aplliance exposed to atmospheric agents (rain, sun,
etc.)
- do not move the appliance when is running.
- the appliance was not designed to be used under rain and must not
be deposited outdoor or in damp places.
• In case of failure and/or malfunction of the appliance, turn it off and
don’t tamper it.
For repairs apply only to the manufacturer or to a service center
authorized by the same and require the use of genuine spare parts.
Failure to comply with the above may compromise the security of the
device.
7
EN
GENERAL WARNINGS
• If you decide not to use a device of this type any more, it must be
made inoperative by cutting the power cord after removing the plug
from the socket.
It is also recommended to make harmless those parts of the equipment
which may constitute a danger, especially for children who might use
an abandoned appliance for their games.
• To avoid dangerous overheating, it is recommended to extend the
power cord to its full length and use the appliance as recommended
in “USING THE MACHINE”.
☞
During the functioning, the socket must be easily accesible
in the event that becomes necessary to unplug the appliance.
Do not place the appliance under a socket so that the wire
doesn’t interfere with the correct use of the machine.
• Do not leave the appliance plugged in unnecessarily. Unplug it from
the power supply when the device is not used.
• After use, always switch off the unit and remove the plug from the
socket.
•
After each use, always perform a thorough cleaning of all parts in contact
with food, as mentioned under “Cleaning the slicer”.
• Do not block the openings, ventilation or heat dissipation slots.
• If the power cord of this appliance is damaged, it must be replaced
by a service center authorized by the manufacturer, as special tools
are required.
Before performing aby operation turn off the appliance
and disconnect the power plug from the socket.
☞
Make sure the power cord does not protrude from the oor
to avoid that someone can pull it also inadvertently knocking
the appliance.