Specifications

CALIBRATION CONFIGURATION
You will need the following equipment when calibrating your power supply:
x 5 ½ digit true RMS voltmeter (DMM) (+
0.05% accuracy) with test leads
x Current shunt 0.01 or 0.001 ohm and connecting wire.
If your product requires calibration and need calibration kit, please contact our sales department at 1-800-654-
9838 for more detail information.
<NOTE>: JUMPER MUST SET BETWEEN +S AND +OUTPUT, –S AND –OUTPUT.
FIGURE 5.1 VOLTAGE CALIBRATION CONFIGURATION
Precision Shunt Resistor
<NOTE>: JUMPER MUST SET BETWEEN +S AND +OUTPUT, –S AND –OUTPUT.
FIGURE 5.2 CURRENT CALIBRATION CONFIGURATION
POWER SUPPLY
(+) Sense
(+) Output
(-) Output
(-) Sense
DMM
(+) Input
(-) Input
POWER SUPPLY
(+) Sense
(+) Output
(-) Output
(-) Sense
DMM
(+) Input
(-) Input
7-2