Specifications

8. Press six times #6 key after pressed UTILITY to advance to then press
ENTER. Use key #6 as () and #4 as () to set EOS Code. (NONE / CR / LF / CR+LF). Press
ENTER key to accept the EOS Code then press CLEAR key to back to metering menu.
9. Press seven times #6 key after pressed UTILITY to advance to then
press ENTER. Use key #6 as () and #4 as () to set LCD backlight. (Always / 5 min / Off).
Press ENTER key to accept the LCD setting then press CLEAR key to back to metering menu.
10. Press eight times #6 key after pressed UTILITY to advance to then
press ENTER key. Use key #6 as () and #4 as () to select the desired buzzer operating mode:
On, Off, or Alarm. Press ENTER key to accept the buzzer setting then press CLEAR key to
back to metering menu.
Note: In ALARM mode, the buzzer sounds only during protection alarm trip events
11. Press nine times #6 key after pressed UTILITY to advance to then
press ENTER key. Use key #6 as () and #4 as () to select the desired Remote Inhibit
operating mode: Off, Live, or Latched. Press ENTER key to accept the buzzer setting then
press CLEAR key to back to metering menu.
OFF
Remote Inhibit Off
LIVE
Self-recoverable Remote Inhibit
LATCH
Latched Remote Inhibit
Remote Inhibit function is Low-active: Short – INH Enabled and Open – INH Disabled
12. Press ten times #6 key after pressed UTILITY to advance to then press
ENTER key. Use key #6 as () and #4 as () to select the desired computer programming
command protocol: SCPI or IEEE488.1. Press ENTER key to accept the buzzer setting then
press CLEAR key to back to metering menu.
Note: The IEEE488.1 protocol is for legacy PDS & PD models, default protocol is SCPI
13. Press eleven times #6 key after pressed UTILITY to advance to then
press ENTER. Use key #6 as () and #4 as () to select and configure AUTHENTICATE
menu options:
a- SERIAL NO.: Press ENTER to see the MAC ID address for the specific
channel being controlled. Press CLEAR key to back to metering menu.
b- INTERFACE: Press ENTER check which interfaces are available on the unit.
Press CLEAR key to back to metering menu.
UTILITY
EOS CODE °
UTILITY
LCD BACKLIGHT °
UTILITY
BUZZER °
UTILITY
AUTHENTICATE °
UTILITY
INH °
UTILITY
COMMAND °
3-8