Specifications

c- CODE: Optional interfaces, such as Ethernet, can be enabled in the field using a
code. Please contact an AMREL representative today.
14. Press twelve times #6 key after pressed UTILITY to advance to then
press ENTER. Use key #6 as () and #4 as () to select Panel Enable Mode or Panel Password
Mode):
a- Panel Enable Mode: Press ENTER then use key #6 as () and #4 as () to
enable/disable (On/Off). Press ENTER key to accept the password then press
CLEAR key to back to metering menu).
b- Panel Password Mode: Press ENTER then press CLEAR key to back to
metering menu).
15. Press ten times #6 key after pressed UTILITY to advance to then press
ENTER. Use key #6 as (
) and #4 as () to select ADDRESS, NETMASK, or GATEWAY):
a- ADDRESS: Press ENTER to input the IP address. Press ENTER key to accept
the address then press CLEAR key twice to back to metering menu.
b- NETMASK: Press ENTER to input the NETMASK. Press ENTER key to
accept the password then press CLEAR key to back to metering menu.
c- GATEWAY: Press ENTER then input the GATEWAY address. Press ENTER
key to accept the address then press CLEAR key twice to back to metering menu.
16. Press nine times #6 key after pressed UTILITY will back to step 1 (System Status). Also you
may press #4 key to back to pre
vious function.
TRACKING SELECTION MODE
The dual channel PDS series has the ability of tracking since it has two outputs. You can set
channel 1 as the master channel then channel 2 will be slave channel or channel 2 as master
channel then channel 1 as slave channel. The slave channel output is identical (synchronized
with) to master channel and is controlled by the master channel. For example: If the voltage
changes by amount “x” in the master channel, the slave channel will also change by amount “x".
Tracking setting procedure:
i. At Metering Mode. Press “ENTER” and “7” key simultaneously
to enter
to Tracking Selection Mode.
ii. Press “CHANNEL” key or “” key to select channel.
iii. Press “ENTER” key to set the tracking option (1 = Master (T) and 2 =
Slave (t)) for each channel.
iv. Press “CLEAR” to back to Metering Mode.
v. Now set the voltage or current at the master channel and the slave
channel will be identical to master channel.
This setting can also be set with the rotary knob. Turning the knob will
select the channel and pressing the knob will select the tracking option, and
holding the knob will go back to Metering Mode.
UTILITY
NETWORK °
UTILITY
PANEL LOCK °
3-9