Specifications

STEPPING MODE
Voltage/Current List Edit Mode.
Voltage/Current step programming permits the user to program a sequence of different voltage outputs with
its applied duration via front panel keypad.
VLIST setting:
1. At metering menu; Press key# 4 (VLIST) to enter into the voltage list edit
mode.
2. Press “CHANNEL” key to select operation channel, if applicable.
3. Use “” or “” to select list step.
4. Press key# 7 (VOLT) to set the list voltage value at this step.
5. Press key# 9 (OV/TIME) to set list dwelling time in millisecond.
6. Repeat step 3 to 5 if need to edit more list steps.
7. Press CLEAR key to go back to metering menu.
ILIST setting:
1. At metering menu; Press key# 5 (ILIST) to enter into the current list edit
mode.
2. Press “CHANNEL” key to select operation channel, if applicable.
3. Use “” or “” to select list step.
4. Press key# 8 (CURR) to set the list voltage value for the selected step.
5. Press key# 9 (OV/TIME) to set the list dwelling time in milliseconds.
6. Repeat step 3 to 5 if need to edit more list steps.
7. Press CLEAR key to go back to metering menu.
Voltage/Current list operation:
1. At metering menu; Press key# 0 (VLIST ON/OFF) or decimal key (
. ) to
enable / disable the voltage/current list operation.
2. When list operation is ON, the display shows “VLIST ON” OR “ILIST ON”.
Note: List operation can only be enabling when output status is ON.
LIST CYCLE
List Cycle is the cycle of loops the step program will be repeated. The stepping function provides loop
control with list cycle function, which instructs the power supply to repeat the stepping function, based on the
list cycle. For example: List cycle is set to 10 and the power supply will cycle the desired steps 10 times.
Set List Cycle:
1. Press UTILITY.
2. Use “” key to select LIST CYCLE, and then press ENTER.
3. Use “” or “” to set the cycle time, and then press ENTER.
4. Press CLEAR twice to back to metering menu.
3-11