Specifications

CONSTANT CURRENT RANGE SELECTION (OPTIONAL)

The PD features a two range of output operating for Constant Current Mode (CC). The user must select the

PD output range corresponding to the output source value, by pressing the key #6 locates at the front panel

keypad, and then the LCD module will display the operating range L / M / H.

Example:

(H) = 0 – 1 Amp / 30 Volt

(M) = 0 – 15 Amp / 2 Volt

(L) = 0 – 30 Amp / 1 Volt

(L/M/H) Range

STEPS TO VIEW “*IDN?” INFORMATION FROM THE FRONT PANEL

Turn on AC Power or push “Clear” button; the front panel display should contain the following

three fields:

4) AMREL – Manufacturer;

5) PD###### – Model Number;

6) Version number.

STEPS TO SET THE EOS MODE FROM THE FRONT PANEL

6) After front panel display is stable, push “Utility”;

7) Then choose “EOS Mode” by pushing “6o” button;

8) Choose “LF+CR” by pushing “2p” button;

9) Push “Enter” button;

10) Push “Clear” button.

<NOTE>: If this is not set to “LF+CR” the output will be ASCII verses a Hex number.

PROGRAMMING DC POWER SUPPLY

OVP LCL

OCP RMT

CH RL RNG LIST STS

OUTPUT OFF

01 L

4-7