Specifications

2) If Users’ local network supports DHCP server, users can just click “Yes” to
configure all equipments to accept DHCP. Otherwise, just click “No” to ignore it.
3) The following panel then shows up for users to choose a unit to run. Users can
select a unit from the instrument list and double click the row. The unit
configuration panel then shows up for users to simply configure the unit.
4) Most of the information in the following device configuration panel is read from
the instrument and displayed to users. It’s not for users to make changes. However,
users still can operate on the following settings: Beep on/off, Output when power
on, VSET, ISET and OUT state by just configuring the corresponding areas
showing in the following panel.
6-6