Use Instructions
Table Of Contents
- Introduction
- Indications For Use
- Contraindications For Use
- For Use With
- Accessories
- System Overview
- User/Patient Safety
- Features
- Physical Buttons
- Graphical user interface
- Definitions
- Instructions
- Inspection and Maintenance
- Cleaning
- Storage and Handling
- Disposal/Recycle
- Troubleshooting
- Error Messages
- Specifications
- Electromagnetic Compatibility
- Appendix
SL5019 Rev. A
13
prevents foreign objects from entering the canister.
F
Powered IV Pole – This motor-powered IV pole is capable of holding four three-liter [3000 mL] IV
bags, one bag per hook.
G
LCD Display –
Provides the operation of rover.
Provides visual display of the fluid volume values of each chamber. Display brightness may also be
adjusted. See the To Adjust the Rover Settings section.
Provides suction values for the canister, system status and error messages.
H
Suction Off/Stop Docking Button– Push the button to stop suction when suction on.
Push the button to stop docking when docking.
I
Pop the manifold out Button – Push the button to pop the manifold out.
J
Speaker (not shown) – Located inside the rover, provides audible event indicators. See the Audible
Event Indicators table.
K
Smoke Evacuator ULPA Filter Compartment – Allows for the installation and removal of a disposable
smoke evacuator filter with an Ultra Low Penetrating Air (ULPA) efficiency rating.
L
Single Vacuum Pump (not shown) – Creates suction for the canister.
M
Casters (four) – Four swivel casters allow the rover its mobility. The four casters have locks to
prevent inadvertent movement during operation.
N
Footswitch Jack - Allow connection to a pneumatic footswitch. When the footswitch is plugged in, the
fan may be turned on or off by depressing the footswitch pedal once for each operation.
O
Footswitch Pedal – Allows turn on or off the Fan by depressing the Footswitch pedal once for each
operation.
P
Infrared Communication Window – Allows data transfer between the docker and rover. Data transfer
is necessary during the docking procedure.
Q
Power Cord Receptacle/Switch – Connect facility power to the receptacle using the rover power cord.
Tap the toggle switch to apply or remove facility power. See the Definitions section for ON and OFF
power symbol definitions.
R
Power Cord Bracket/Cord – Store the power cord on the bracket. Use the power cord to connect the
rover to facility power.
S
Specification Label –
T
Auxiliary Suction Ports (optional) – Allow connection to a hospital wall suction regulator if an alternate
suction source is required. See the Appendix, To Use Auxiliary Suction Ports (optional) section.
U
Auxiliary Suction Ports Label –
V
Quick Reference Cards – Allows for quick access to specific High suction device information and
Tipping Hazard WARNING.