Use Instructions
Table Of Contents
- Introduction
- Indications For Use
- Contraindications For Use
- For Use With
- Accessories
- System Overview
- User/Patient Safety
- Features
- Physical Buttons
- Graphical user interface
- Definitions
- Instructions
- Inspection and Maintenance
- Cleaning
- Storage and Handling
- Disposal/Recycle
- Troubleshooting
- Error Messages
- Specifications
- Electromagnetic Compatibility
- Appendix
SL5019 Rev. A
32
Figure 14 To Test UV light
To Adjust the Rover Settings
1. Make sure the power cord is connected between the rover and facility power.
2. Make sure the power switch is in the ON position and the HIGH SUCTION DEVICE WARNING has been
acknowledged. Make sure the manifold is installed correctly.
3. From the user interface, tap the Settings key to open the system setup view (Figure15).
4. From the system settings view, tap as needed to select the system settings you want to adjust.
5. After setting adjustments are completed, the custom settings will be saved. For more setup information,
please refer to the “Settings View” section and the “System Setting Options” section.
Figure 15 To Adjust the Rover
NOTE: After adjusting the rover system settings, disconnect the rover from facility power and wrap the power
cord around the power cord bracket. The rover is now ready to be used in an operating room setting.
Before the Procedure
To Setup the Rover
WARNINGS：
• Upon initial receipt and before each use, inspect each component for damage. DO NOT use any
equipment if damage is apparent or the inspection criteria are not met. See the Inspection and