User manual

3
To enter a
password
:
1. N3300: Select the “
Enter Password”
by opening the keypad setup door and pressing
the Quick Access key once.
A600: Press the Off Line key, then the Setup key. Use the Group key and Feature
keys to select the Enter Password feature.
2. Press the Value keys to change the first character which is blinking.
3. Press the
Enter
key. The character is covered with ‘*’ and the blinking cursor ‘_’
advances to the next position to the right. Continue steps 2 and 3 until the complete
password is entered.
4. After the last character is entered press the
Enter
key one more time to select the
password. If the password is correct the first password protected feature is
automatically selected.
Example to enter password of ‘ABC’
Keypad Display
Select the
Enter Password
feature. Enter Password
Press Value keys to begin entering characters. _
Press Value keys until ‘A’is displayed. A
Press Enter. *_
Press Value keys until ‘B’ is displayed. *B
Press Enter. **_
Press Value keys until ‘C’ is displayed. **C
Press Enter. ***_
Press Enter again to verify password.
The following message is displayed if the password is not correct.
"Invalid Password"
"Please try again”
After three unsuccessful attempts the following message is displayed. The printer must be
powered off then on before attempting to enter another password.
"Password Timeout"
"Turn Printer Off"
NOTE:
On the N600 printer, turn the printer power off and remove the plug from the jack
labled 5VDC on the Network Interface enclosure and then reconnect. Powering
the printer off does not power off the network interface.