User manual

Setting the Default Gateway

The same procedure used to set the IP address is used to set the

Default

Gateway

Set Gateway

Note the first character changes to ‘G’ when setting the gateway feature.

G0.0.0.0

Entering an invalid Gateway address will result in the following message:

"Invalid IP Adr"

" Please Retry "

Running the Loop Back Test

Running the loop back test results in the LAN interface transmitting a 23 line ASCII roll

pattern to the printer on the parallel interface. A valid password must be entered before

accessing this feature.

Run Loopback

NOTE:

This test may only be performed when no print jobs are pending or data is

present in the FIFO.

CAUTION:

This test should be run using 8.5 x 11 inch paper, or set the right margin to

ensure that the printhead does not print off of the paper.