User`s guide

User Manual 57
Printer Editing Commands
These commands are saved into the EEPROM
<STX>KI7n Sets Media Type (DT/TT)
<STX>KI8n Sets Baud Rate
<STX>KI9bdpt Sets Baud Rate, Databits, parity, stop bits
<STX>KI<m Sets symbol set for smooth fonts
<STX>KIXnnnn Sets label length for continuous label
<STX>KI0n Sets cut mode
<STX>KI5nn Sets the gap distance
<STX>KI;n Sets control code set
<ESC>KI;n Sets offset value for cutting or peeling
<ESC>KI:n Sets horizontal shift position
<ESC>@0 Clears Flash memory
Printer System Level Commands
These commands will not be saved into the EEPROM
<STX>AwmmddyyyyhhMMjj Sets date and time into the RTC
<STX>a Requests a <RS> following printing of a label
<STX>cnnnn Sets continuous label length
<STX>Dnnnnnnn Clears the memory contents
<STX>Ennnn Sets copy count
<STX>e Select Gap Media sensing
<STX>fnnn Sets present position and automatic backfeeding
<STX>G Prints Stored Label format
<STX>Imbfnnn...n Downloads a graphic file
<STX>J Will cause the printer to pause between each label (Press
Feed key to print next label.)
<STX>j Cancels the pause condition (<STX J>) command
<STX>KQ Inquires printer memory configuration
<STX>L Enters label formatting mode
<STX>Mnnnn Sets Maximum label length
<STX>m Sets unit of measure to metric
<STX>n Sets unit of measure to inches
<STX>Onnnn Sets start print position
<STX>P Enters in to printer's HEX mode
<STX>Q Clears memory (Ram and Flash)
<STX>qn Clears memory module
<STX>r Sets reflective sensor for Gap mode
<STX>Sn Sets label feed rate
<STX>T Prints test pattern
<STX>Unncccc Replaces the data of a specified field
<STX>Vn Sets cutter and Peeler modes
<STX>v Inquires printer version
<STX>Wn Inquires the graphics/fonts and memory status
<STX>xmtn…n Deletes file form memory