Instruction Manual

User's Guide 19
Loading Media When Cutter is Equipped
1. Follow the same procedure as “Loading Media”.
2. After you thread the media over the platen roller, thread the media through the horizontal gap
at the cutter module.
Note: The printer must be configured for Peel and Present Mode. This setting may be made
in the windows driver, utility software, label design software or using printer
commands from the host.
Figure 13 - Loading Media - Cutter
Caution: When removing a label from a printer with the Cutter option make
sure that the cutter is not rotating before removing the label or when
manually opening the printer.
Cutter