User`s guide

36
Procedure to Enter into Set-up Mode
1. Power on the printer.
2. When the “ READY” message is displayed on the LCD, press [PAUSE] once
to enter off-line mode. Press and hold [FEED] and then [PAUSE] buttons.
Release buttons.
3. Press and hold [FEED], then press [PAUSE] button repeatedly to scroll to
the feature that you want to change.
4. Press [CANCEL] button once to select feature.
5. Press and hold [FEED], then press [PAUSE] button repeatedly to scroll to
the desired value of the displayed feature.
6. Once the desired value is displayed, press [CANCEL] button to save it.
After pressing the [CANCEL] button an * should appear in the last column.
The * is used to designate the stored value in non-volatile memory.
7. Press the [PAUSE] button once to save, and again to return to normal
mode.
Note: Do not enter set-up mode while the printer is printing or while the host is
sending data.