Operator`s manual

Figure 4.11: Carriage Drive Motor
4.5.23: Carriage Drive Spool Removal and Replacement - Figure 4.11
It is possible to replace a damaged or defective drive spool without removal of the carriage
motor from the print mechanism. To replace the drive spool:
1. Remove carriage drive cables (see Paragraph 4.5.18).
2. Remove defective spool by loosening the set screw and slipping spool (1 from the
motor shaft.
3. Install new drive spool. Refer to Paragraph 4.5.2 1, step 6.
4. Replace carriage drive cables (see Paragraph 4.5.18) to complete the installation.
4.5.24: Printhead Removal and Replacement - Figure 4.12
1. Remove top cover (see Paragraph 4.5.1)
2. Set the printhead adjustment lever (167) in the last detent position to provide the
maximum printhead to platen gap.
4-24