Operator`s manual

Figure 4.15: Printhead to Platen Gap Alignment
4.5.35: Lower Paper Guide/Paper Out Sensor Removal a Replacement - Figure 4.16
1. Remove top cover (see Paragraph 4.5.1).
2. Remove electronic chassis (see Paragraph 4.5.4).
3. Remove three screws (184) securing lower paper guide (190) to platen (185).
4. Remove four screws (15, 16, 17) securing printer mechanism to bottom cover (2)
and lift rear of printer mechanism enough to remove lower paper guide (190).
5 . Replace in reverse order.
6 . Once installation is complete the lower paper guide must be aligned with the platen
as shown in Figure 4.17.
4-36