User's Manual

4. For universal type of LNB, select Universal from LNB Type item and input the LNB

frequency value on L.O.Freq. and L.O.Freq.Low by using VOL ◀▶or numeric key.

For standard type of LNB, select Standard from LNB Type and input correct value on

L.O.Freq..

5. While only 1 antenna is in use, set the 0/12V switch and DiSEqC mode to Disable. In

case of STANDARD, select OFF from 22KHz. If more then 1 antenna is in use, select 0V

or 12V from 0/12V switch, or select a proper position from Mini A, Mini B, DiSEqC 1 ~

DiSEqC 4 by different DiSEqC type as you are using DiSEqC switch.

6. Select Search Channels on the TP Configuration press OK, all the available TP will be

searched automatically.

7. Move to desired TP with CH

▲▼ on the RCU. If there are no transponder data which

you want, move to Add and press OK button.

8. Select the desired satellite. And input correct values of Frequency, Polarization and

Symbol Rate. Select the Polarization value as Hor or Ver. If you did not know accurate

polarization value select Auto.

You should find the correct data from satellite magazine or internet(http://www.SATCODX.com).

9. After all the values are input, select Search Channels and wait until the automatic

search is completed.

If FTA only is selected as YES, only free channels will be searched without scrambled

pay channels. Otherwise all channel with scrambled pay channels will be searched.

Scrambled pay channels is marked as $ at the beginning of the channel name.

After successful completion of channel searching, move to TV Channels or Radio

Channels on MAIN MENU to select currently received channels. Then you should select

the TV channel or Radio channel which you want. After then you can watch the TV

program or listen to the radio.

TP Configuration

Note