User's Manual

<DiSEqC 1.2 Limit Settings>
If you have a DiSEqC 1.2 motoried system to control your satellite antenna you have to
make the following setting. First, you must select ON on DiSEqC 1.2 of LNB Setting in
the TP Configuration. < Please refer to the TP Configuration section >
1. Select DiSEqC 1.2 Limit Settings of the installation.
2. You should set the East Limit and West Limit of your satellite antenna If you use the
satellite receiver at first. Press OK button on the Change Limit item, set the East/West
Limit.
3. Select satellite you want and DiSEqC1.2 Pos. will be set automatically.
Satellite / DiSEqC1.2 Pos.
The Satellite shows current name of satellite, and DiSEqC1.2 Pos. shows positioner
value of the current satellite.
DiSEqC1.2 Command
DiSEqC1.2 Command changes the current mode between Installer and User.
Movement
In User mode this is used to tune the position of the motor. In Installer mode this is used
to search for the position of a satellite manually.
Store
Stores the current position of the motor for the selected satellite name.
Goto
Moves the motor to the stored position of the selected satellite name.
9
DisEqC 1.2 Limit Settings