User's Manual

S/W Version
Show software version. Select S/W Version.
Initialization
Press OK button from Initialization. If you want initialization, select OK button,
otherwise, select any button of remote controller. The receiver will be turned off and on
automatically after 1~2 seconds to initialize all the values to factory setting mode.
As this procedure will clear and set to factory default values, end users are not
recommended to operate this function.
21
System Settings
4.5 CA Information
CA modules and Smart Cards are licenced to Service Providers.
If you want to watch TV programmes from a Service Provider you must use a CA
module(Conditional Access) with a Smart Card. If no CA module is used you can only
watch FREE TO AIR TV programmes.
Press CA Information of MAIN MENU. Then, the following sub menu will be shown as
below.
You will get access to information and menus connected to the Common Interface(CA)
Module.
The mains plug must not be plugged in before inserting the CA module.
Note