User Manual

IV
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
 Consult the dealer or an experienced technician for help.
Use only shielded I/O cables to connect I/O devices to this equipment.
You are cautioned the changes or modifications not expressly approved by the party
responsible for compliance could void your authority to use the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device will not cause harmful interference, and (2) this device must
accept any interference it receive including interference that may cause undesired operation.
This device and its antenna(s) must not be co-located or operating in conjunction with any
other antenna or transmitter.
Canadian EMI Compliance Statement
This Class B digital apparatus meets all requirements of the Canadian Interference -
Causing Equipment Regulations.
European Union CE Marking Declaration
This product has been tested and found to comply with the EMC requirement subject to the
EU directive for CE marking.
CE DECLARATION OF CONFORMITY
Is herewith confirmed to comply with the requirements set out in the Council Directive on the
Approximation of the Laws of the Member States relating to Electromagnetic Compatibility
(89/336/EEC), Low-voltage Directive (73/23/EEC) and the Amendment Directive
(93/68/EEC), the procedures given in European Council Directive 99/5/EC and 89/3360EEC.
The equipment was passed. The test was performed according to the following European
standards:
 EN 300 328 V.1.6.1 (2004)
 EN 301 489-1 V.1.4.1 (2002) / EN 301 489-17 V.1.2.1 (2002)