Instruction manual

27
maximum limits of an expected worst-case operating range, with AC
power still present.
Send E-mail:
If this box is checked, an e-mail alarm notification will
be sent when a battery voltage fault occurs, and AC power is
present.
The alarm opens the internal LVD contactor, and automatically
reconnects when the battery voltage returns to an expected normal
operating range.
5.4.
Network Setup
This page allows you to configure the network settings of the power
supply. To save any changes to the network settings, click on Save
Settings at the bottom of this page and power supply will reboot.
5.4.1. NETWORK
MAC Address: Displays the MAC address assigned to the power
supply.
Enable DHCP: Turn on this setting if your network is using a DHCP
server to automatically assign IP addresses (DHCP is enabled by
default). To manually assign a Static IP address to the power supply,
uncheck the
Enable DHCP
box and then set the following settings.
IP Address: Specify a unique IP address for the power supply.
Subnet Mask:
Specify the mask for the subnet the power supply is
located on.
Gateway: Specify the IP address of the default router (gateway)
used for connecting attached devices to different networks.
Primary DNS: Specify the IP address of the Primary DNS Server for
your network.
Secondary DNS: Specify the IP address of the Secondary DNS Server
for your network.