Product Specification Product Specification WN8522B 1-LF-MT IEEE Dual Band 802.11n USB2.0 module for DTV v.
Product Specification Table of Contents Chapter 1 Introduction _____________________________________________________ 4 1. Introduction ________________________________________________________ 4 1.1 Product Features____________________________________________________ 4 1.2 Applications _______________________________________________________ 4 Chapter 2 Hardware _______________________________________________________ 5 2.1 General Overview __________________________________________________ 5 2.
Product Specification Revision History Edition # Reason for revision Issue date Written by V 01 ♦ Initial Document April 7, 2009 Katherine Hsieh V 02 ♦ Data Transfer Rate added April 27, 2009 Andre Lin V 03 ♦ Antenna spec.
Product Specification Chapter 1 Introduction 1. Introduction WN8522B 1 is a dual band wireless 802.11n USB module for DTV, Bluray Players, etc.. which enables consumer devices to support wireless connectivity over 802.11a/b/g/n WLAN . 1.1 Product Features ♦ High speed for wireless LAN connection, RX up at 300 Mbps data rate. ♦ ♦ Backward compatible to the existing IEEE 802.11a/b/g WLAN infrastructure. Support USB v2.0 1.
Product Specification Chapter 2 2.1 General Overview ♦ ♦ USB 2.0 Interface 2 * antenna connectors Hardware 2.2 Hardware Architecture Broadcom 4323 single chip USB2.0 2.3 Main Chipset Information BCM4323: MIMO MAC + Baseband processor and RF with fully forward compatible with IEEE 802.11n draft2.0 standard. 2.4 PCB dimension 2.5 Antenna Features Antenna VSWR is < 2.5. Antenna Average Gain in the Main Cut is > -6dBi.
Product Specification 2.
Product Specification Chapter 3 Specifications ♦ Frequency Band: Draft 802.11n Radio: 2.4 GHz 802.11g Radio: 2.4 GHz 802.11b Radio: 2.4 GHz USA – FCC Canada – IC Europe – ETSI France Japan – STD-T66/STD-33 2412~2462MHz (Ch1~Ch11) 2412~2462MHz (Ch1~Ch11) 2412~2472MHz (Ch1~Ch13) 2457~2472MHz (Ch10~Ch13) 2412~2484MHz (Ch1~Ch14) 802.11a Radio : 5 GHz 5.150~5.250GHz 5.250~5.350 GHz 5.470~5.725 GHz 5.725~5.850GHz ♦ Operating Channels: IEEE 802.
Product Specification ♦ Data transfer rate for 802.11a are (6, 9, 12, 18, 24, 36, 48, 54) for 802.11b are (1, 2, 5.5, 11) for 802.11g are (6, 9, 11, 12, 18, 24, 36, 48, 54) for 11n ht20 MCS15 130M MCS14 117M MCS13 104M MCS12 78M MCS11 52M MCS10 39M MCS9 26M MCS8 13M MCS7 65M MCS6 58.5M MCS5 52M MCS4 39M MCS3 26M MCS2 19.5M MCS1 13M MCS0 6.5M MCS14 243M MCS13 216M MCS12 162M MCS11 108M MCS10 81M MCS9 54M MCS8 27M MCS7 135M MCS6 121.5M MCS5 108M MCS4 81M MCS3 54M MCS2 40.
Product Specification RX: mA Max, @MCS15, 40MHz Power Saving: mA Radio OFF mode: mA ♦ ♦ ♦ ♦ Operating Temperature: 0 ~ 40 oC ambient Storage Temperature: -10 ~ 70 oC ambient Humidity: 5 ~ 90% and must be non-condensing Regulation and certification compliance available: ♦WHQL ♦ETSI/CE ♦ESD: EN61000-4-2, which specifies 4kV contact and 8kV air discharge.
Product Specification References ♦ ♦ ♦ ♦ Ralink Reference Design Functional Specification IEEE 802.11b Standard Specification IEEE 802.11g Standard Specification IEEE 802.11n draft Standard Specification FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Product Specification IMPORTANT NOTE: This module is intended for OEM integrator. The OEM integrator is still responsible for the FCC compliance requirement of the end product, which integrates this module. 20cm minimum distance has to be able to be maintained between the antenna and the users for the host this module is integrated into. Under such configuration, the FCC radiation exposure limits set forth for an population/uncontrolled environment can be satisfied.
Product Specification label: This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 2.4GHz operation of this product in the U.S.A. is firmware-limited to channels 1 through 11.
Product Specification WN8522B 1 13