Product manual

7. WIRING

1. Shut off the circuit breaker for the well system. Loosen

the silver screw on top of the control and remove cover

to expose the control wires.

Electrocution hazard. For your safety,

the information in this manual must be followed to

minimize the risk of electric shock, property damage

or personal injury. Properly ground to conform with all

governing codes and ordinances.

2. The 12 gauge wire leads are pre-stripped and ready

to accept standard wire nuts. Each wire is color coded

to correspond with the diagram below. Use water tight

conduit, connections, and wire nuts for an outside

application.

3. Wiring is similar to a traditional mechanical pressure

switch. Two leads are connected to line supply, while

the other supply the pump motor or starter. Wire the

control to the line supply and pump motor or pump

starter as required by the manufacturer's instructions.

It is recommended that service switch be installed in

addition to the circuit breaker. The disconnect for the

controller must break all incoming power lines. This

should interrupt line voltage and be installed near the

Well-X1

and labeled appropriately.

4. After completing the wiring, reattach top cover and

tighten screw. Ensure no loose wires protrude from the

control.

LINE

MOTOR

BLACK

WHITE/STRIPE

BLUE

WHITE

SCREW