Instructions / Assembly

Warranty

WX Models: Seven (7) Year Limited Warranty

Visit www.amtrol.com for complete warranty details and to register

the serial number of your well tank.

Start Up

Fine Tuning Procedures

Many times the actual pressure switch will vary from the standard

pressure range indicated. These variations could cause a

momentary lag of water delivery, as the pressure switch is not

tuned to the Well-X-Trol precharge pressure.

1. Fill the system and Well-X-Trol until pump cuts off.

2. Open one or more fixtures to drain the Well-X-Trol.

3. If there is a momentary pause in the water flow from the time

the Well-X-Trol is emptied and the pump starts, adjust pump

cut-in setting clockwise slightly (Figure 2).

4. Close fixtures and refill Well-X-Trol to pump cut off. Check

time to fill.

5. Open fixtures and see if pause in water is eliminated. If not,

continue adjusting pressure switch.

Adjusting Precharge After Installation

Step 1. Drain tank of all water. Check precharge pressure in

the Well-X-Trol Tank.

Step 2. Release or add air as necessary to make the recharge

pressure 2 psig below the pressure switch pump cut-in setting.

Maintenance

A qualified professional should check the complete system,

including the Well-X-Trol, yearly and more frequently as the

system ages.

Pressure Adjustment:

• Clockwise to increase

cut-out pressure.

• Counter-clockise to decrease

cut-out pressure.

Figure 2

1400 Division Road, West Warwick, RI 02893 USA

T: 800.426.8765 F: 800.293.1519