User's Manual

28 Installation WAVE 2-Way Wireless Accessories and Adapters for Touch Panels
Installing the WAV-PKM
The WAV-PKM is secured with two screws once it is mounted to a Mini-TiltScreen
touch panel (Figure 30). Refer to the Black/White Mini-Touch Panels (Firmware ver-
sion G3 or higher) instruction manual for more information on Mini-TiltScreens. To
install the WAV-PKM, perform the following steps:
Mini-
TiltScreen touch
panel screw holes
Mounting screws
1. Remove the mini-touch panel rear connector cover by placing your thumb on
the mini-touch panel rear housing, and your index finger under the center of the
rear connector cover as shown in Figure 31.
Thumb
position
Index finger goes
under the cover
Connector
cover
2. Press down with your thumb, and at the same time, lift up with your index fin-
ger. The cover will pop loose from the mini-touch panel housing.
Figure 30
WAV-PKM mounting screws
Figure 31
Removing the mini-touch panel
rear connector cover