Instruction manual

Initial APWeb Setup by Network Admin
11
APWeb Instruction Manual
You also have the option of displaying channel numbers instead of channel names.
To remove customized channel names in the XBar:
1.
From any page in the site, click the Configuration link.
2. Under Bootup Operations, unselect Discover Channel Names.
3. Click Apply, and reboot when prompted to do so.
Only the channel numbers will display in the XBar.
Enabling Audio Control
If the system has audio, volume and input gain controls are available from the XBar; however, they must
be enabled first from the APWeb Configuration page.
Important: If the system does not have audio, volume and input gain must not be enabled.
To enable audio control in the XBar:
1.
From any page in the site, click the Configuration link.
2. Under Audio Support, select Allow Gain Control and/or Allow Volume Control.
3. Click Apply. The next time the XBar is launched, the enabled audio features are available.
After audio adjustments are made, you can disable one or both of these features so the user cannot
change the settings (the adjusted settings will remain in effect until the audio control option is enabled
again and new adjustments are made).
Setting the Size of the XBar Window
The size of the XBar applet can be changed from the APWeb Configuration page. The default size for
the window is 800x580 (minimum = 300x300, maximum = 2000x2000). You may need to experiment a
little to find the optimal display size for your PC.
To set the size of the XBar applet window:
1.
If the XBar is open, close before proceeding.
2. From any page in the site, click the Configuration link.
3. Under Window Size, enter the desired width and height for the window.
4. Click Apply. The next time the XBar is launched, it will open at the new setting size.
Setting the Initial VM to Display
From the APWeb Configuration page, the initial virtual matrix can be set for executing switches. The
VM is displayed in the VM title block in the upper left corner of the XBar. The default VM for executing
switches that will display for all XBar Controllers that are launched for the system can be specified on
the APWeb Configuration page.
To set the initial virtual matrix that will display in the XBar:
1.
From any page in the site, click the Configuration link.
2. Under Initial VM Displayed, enter the virtual matrix number.
Note: If you want the default VM to be the first virtual matrix discovered during bootup (no matter
what its number), enter a value of -1.
3. Click Apply. The next time the XBar is launched, the newly designated default VM will display in
the VM title block.