Instruction manual

Using APWeb
26
APWeb Instruction Manual
Updating Status on the XBar
The XBar can be updated from the VM Selection Pad to show changes in system status. This can be
helpful when the XBar is used simultaneously by multiple users or when other control options (such as
control panels or external serial controllers) are also being used.
To update system status when using multiple control points:
1.
Click the VM title block in the upper left corner of the XBar.
The VM Selection Pad dialog box opens.
2. Click Update Status.
The most current routing state is displayed.
3. Close the VM Selection Pad.
Executing Macros
A macro is a sequence of control commands that are executed simultaneously. Macros can be executed
on the routing system from the Execute Macro page.
Note: If you need additional macros, contact your Network Administrator.
To execute a macro:
1.
From any page in the site, click the Execute Macro link.
2. Click the macro button for the macro you want to execute.
When the text on the macro button turns green, the macro has successfully executed.
(If the text on the macro button turns red, the macro failed to execute. Click again. If still not
successful, contact your Network Administrator.)
FIG. 11 Execute Macro page
Macro list