Instruction manual

Product Overview and Specifications
12
Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver
HDMI TX and Multi-Format TX LEDs
Note: For detailed behavior of the NetLinx Link/Act and Status LEDs on the module’s front, see
page 55. For detailed behavior of the RJ-45 connector LEDs on the module’s rear, see page 42.
Wallplate TX LEDs
* The LEDs for Digital Video, Analog Video, and Audio each indicate the configured state of the connectors,
not necessarily the presence of signals through the Wallplate TX.
Note: Detailed behavior for the NetLinx-L (Link) and NetLinx-S (Status) LEDs is on page 55, and
basic information for the LEDs on the RJ-45 connector on the rear of the Wallplate is on page 42.
Tip: If the Wallplate TX is installed in a location where it is difficult to check the LEDs on the bottom
edge, slide a white piece of paper or a small mirror under the edge to view LED status.
HDMI TX and Multi-Format TX Indicator LEDs
LED Normal Display Indicates
Power Green Power is applied to the Transmitter Module.
Digital Video Green A digital video signal is present through the Transmitter Module.
Audio Green Embedded audio signal is present through the Transmitter Module.
Analog Video
(Multi-Format TX
only)
One of the 3 LEDs
will be Green
The type of analog video present through the Multi-Format TX:
• C (composite) or Y/c (two component)
• Y/PB/PR or RGB (three component)
• RGBHV (five component) or RGBS (four component)
IR TX Red IR TX active communication
IR RX Yellow IR RX active communication
232 (Serial) TX Red Serial TX active communication
232 (Serial) RX Yellow Serial RX active communication
NetLinx Link/Act Green Active LAN connection to an AMX Network
(Blinking = #3 Toggle OFF)
NetLinx Status Green LAN connection is active
CEC OFF CEC is not currently supported
USB Yellow USB is not currently supported. This functionality will be available in
a future firmware upgrade.
Wallplate TX Indicator LEDs
LED Normal Display Indicates
Digital Video
(default)
Green When the Wallplate TX has been configured* to pass HDMI
(for SEND_COMMAND information, see page 77).
Analog Video One of the 3 LEDs
will be Green
When the Wallplate TX has been configured* to pass one of the
following types of analog video (for SEND_COMMAND
information, see page 77):
• C (composite) or Y/c (two component)
• Y/PB/PR or RGB (three component)
• RGBHV (five component) or RGBS (four component)
Audio Green When the Wallplate TX has been configured* to pass analog audio
as the audio source being embedded on the DXLink output
connection (coupled with either the analog or digital video input
path); for SEND_COMMAND information, see page 80.
Power Green Power (from switcher) is applied to the Wallplate TX
LED (bottom edge)
NetLinx - L (Link) Green Active LAN connection to an AMX Network
(Blinking = #3 Toggle OFF)
NetLinx - S (Status) Green
Off
• Speed status is 100 Mbps
• Speed status is 10 Mbps
DXLink Yellow Yellow
Flashing
Off
• Authenticated HDCP (handshaking has occurred successfully)
• Video is active; no HDCP
• No Video
DXLink Green Green DXLink connection is established