Instruction manual

Product Overview and Specifications
15
Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver
Power Jack
Important: If local power is used for the Transmitter, it must only come from the provided desktop
power supply, which must not be altered in any way.
The power receptacle is a 2.1 mm DC jack for connecting power. Power can come from a locally
connected DC supply of 12 V. The automatically adjusting universal 110/220 IEC power supply is
provided. The power supply is ENERGY STAR
®
qualified to ensure maximum efficiency and savings.
Note: The Transmitter Module can also be powered through the DXLink connector when it is
attached to a DXLink Input Board in an Enova DGX 16/32. We recommend calculating the power
budget for the switcher to maintain the redundancy of its power supplies (see page 34).
Wallplate TX Rear View
Located on the rear of the Wallplate TX are a DXLink (RJ-45) connector and a DIP switch.
DXLink Output Connector
The DXLink (RJ-45) connectors transport digital video, embedded audio, bidirectional control, and
Ethernet (SEND_COMMANDs only) over twisted pair cable to DXLink devices or boards, including
digitally transcoded analog video signals. The DXLink path supports HDCP. The DXLink line also
supports power from an Enova DGX 16/32 or from some Enova DVX Solutions to power the Wallplate
TX. For pinout and LED information, see page 42.
DIP Switch
For information on the DIP switch, see page 21.
Special Product Information for Transmitters
If a DVI-D signal is used (via a DVI-to-HDMI cable adapter), the advanced audio support from HDMI
will not be available.
FIG. 6 Wallplate TX rear view (shown with mounting bracket removed)
DIP switch
DXLink connector