Instruction manual

Installation and Setup
42
Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver
Twisted Pair Cable Pinouts
The pinout in FIG. 20 is for twisted pair cable that connects to the ICS LAN 10/100 connector or to the
DXLink connector on the modules and the Wallplate TX.
Use either the T568A or T568B pinout
specification for termination of the twisted pair cable used between the modules in a standalone setup or
between modules or Wallplate TX and an enclosure in a full system.
In a typical installation, the cables should be stretched to their full length between modules or between
modules and an enclosure. Service loops or coils of the cable may reduce the overall cable performance
and should be minimized whenever possible.
RJ-45 LEDs
ICS LAN 10/100 Connector LEDs
The following information applies to the LEDs on the ICS LAN 10/100 connector on the modules
(FIG. 21). Note that #1 Toggle must be set to ON or ICS LAN functionality will not be provided.
FIG. 20 Twisted pair cable pinouts for Ethernet connectors
Yellow LED
Green LED
LEDs on module
FIG. 21 Module ICS LAN 10/100 connector LEDs