Instruction manual

Installation and Setup
54
Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver
Manual Mode
Manual Mode allows the user to configure the resolution that the video will display through a destination
device. Manual Mode defaults to 1280x720p @ 60 Hz. This default resolution can be changed in two
ways:
Use the VIDOUT_RES_REF SEND_COMMAND to set the resolution and refresh rate
(for details, see page 73).
When used as a direct output of an Enova DGX 16/32 DXLink Output Board, use DGX
Configuration Software to set and persist the Manual scaling resolution for the connector on
the DXLink Output Board; the DXLink Output Board sends the scaling resolution data to the
HDMI RX.
Note: The aspect ratio can also be set on the DXLink Output Board using DGX Configuration
Software. The data is persisted on the board and sent to the HDMI RX.
Persistence of Scaling Options
The HDMI RX defaults to “Auto” when power is cycled. The scaling option can be persisted using one
of the three following methods:
Using the Scaling button (see instructions below).
Using the PERSISTAV SEND_COMMAND (for details, see page 88).
Using DGX Configuration Software to set and persist the scaling option for the connector on
the DXLink Output Board on the Enova DGX 16/32; the DXLink Output Board sends the
scaling option data to the HDMI RX.
Using the Scaling Button to Persist a Scaling Option
The factory default is for the HDMI RX to revert to the Auto option if power is cycled. If you want the
unit to remain in either Manual or Bypass Mode when power is cycled, use the following instructions.
To persist a scaling option on power cycle:
1.
Press and release the Scaling button until the LEDs cycle to the option immediately before the one
you want to persist.
2. Press and hold the Scaling button about 5 seconds until the desired LED blinks green (indicating
that option will persist on power cycle), then release.