Instruction manual

Network Configuration
59
Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver
Factory Default Parameters
Device IDs
Factory Default Parameters
Parameter Value
MAC Address As set in Factory
Serial Number As set in Factory
Ethernet Mode Auto (i.e., speed, duplex, both, auto)
IP Addressing Mode DHCP
IP Address (for static mode) 192.168.1.2
Netmask (for static mode) 255.255.255.0
Gateway (for static mode) 192.168.1.1
DNS1 (for static mode) 192.168.1.1
DNS2 (for static mode) 192.168.1.1
DNS3 (for static mode) 192.168.1.1
DNS Domain amx.com
Hostname Last 7 digits of the serial number
Master Connection Mode NDP - For details, see page 107.
Master URL (for TCP and UDP
URL modes)
“” (blank)
Master Connection Port Number
(for TCP and UDP URL modes)
1319
Friendly-Name “” (blank)
Note: If the Friendly Name is non-blank, both Friendly Name and Location
are concatenated to make NDPSTRING2, otherwise NDPSTRING2 is
generated from the unit’s serial number.
Location “” (blank)
Stored MAC Address of Master
(used for NDP binding)
00:00:00:00:00:00
ICSP Device Number 0 (0 = receive dynamic device number from Master)
System Number 0
Telnet Port 23
A value of 0 disables the Telnet server. Telnet is enabled by default.
CTOF Time 5 (0.5 seconds)
CTON Time 5 (0.5 seconds)
Device IDs
Model ID (16-bits) Bound ID (16-bits) Unbound
HDMI-TX Module
(AVB-TX-HDMI-DXLINK)
0x017C 0x014B
Multi-Format TX Module
(AVB-TX-MULTI-DXLINK)
0x017F 0x014B
Multi-Format Wallplate TX
(AVB-WP-TX-MULTI-DXLINK)
0x017E 0x014B
HDMI-RX Module
(AVB-RX-DXLINK-HDMI)
0x017D 0x014B