Instruction manual

NXB-AP-1000 Interface – Additional Info for Network Admin

100

Epica DGX 16 and Epica DGX 32 Instruction Manual

Embedding the XBar Applet

The XBar applet can be embedded in a custom website by using the applet tag shown below.

Make any of the following adjustments to the code to fit your particular system’s requirements.

 Replace the code base value with the IP address for your system.

 Set the width and height for the display based on the initial virtual matrix size (smaller VMs

look fine in a smaller size, while larger VMs require a larger size to minimize scrolling).

 Optional – Specify the "InitialVM" value, or the lowest numbered VM will display by default.

 Optional – Include the "VMLockDown" information if you want to limit control to a

particular virtual matrix; otherwise, all virtual matrices will be accessible from the VM title

block. Specify "locked" or "unlocked" for the value. The XBar defaults to the unlocked state

if this option is not included in the tag.

 Optional – Specify the "AllowGain" value, if you want the input gain adjustment feature

enabled. Specify "true" for the value.

 Optional – Specify the "AllowVolume" value, if you want the output volume adjustment

feature enabled. Specify "true" for the value.

Important: If you do not want either or both of the “Allow Gain” and “Allow Volume” options, omit

those parameter(s) entirely.

XBar Applet Tag

<HTML>

<BODY>

<APPLET code="CrossBar.class" codebase="http://192.168.0.251"

archive="CrossBar.jar" width=400 height=500 >

</APPLET>

</BODY>

</HTML>