Instruction manual

Appendix B – Managing Configuration Files
118
Epica DGX 16 and Epica DGX 32 Instruction Manual
To launch XNConnect:
1.
From the Start menu, select Programs.
2. Select AutoPatch Applications (or other file group you specified during the installation).
3. Select the XNConnect folder.
4. Select XNConnect.
The XNConnect program opens.
When XNConnect is open, two options are available for accessing the information:
 Discover the system (recommended). This works for both conventionally and automatically
configured systems (see page 116).
 Open a copy of the .xcl file located in the MyXCL folder on the AMX AutoPatch CD.
The .xcl file is only available on the CD if the system was conventionally configured (see
page 116).
Discovering a System
The discovery process queries the attached system for configuration information and properties,
including information regarding assigned signals and virtual matrix definitions. The discovery process
may take several minutes to complete.
We recommend disconnecting any third-party control devices from the enclosure’s serial ports before
starting the discovery process.
To discover a system:
1.
Disconnect any third-party control devices from the enclosure’s serial (Control) port.
2. Connect the enclosure to the PC (see page 29). (For systems with multiple enclosures, you can
connect any of the enclosures to the PC as long as all of the enclosures are linked together.)
3. (If not already open) Launch XNConnect (see above).
4. Open the Communication menu; select Serial Port.
Getting Started dialog box