Instruction manual

Appendix D – Programmer’s Interface for System Diagnostics
141
Epica DGX 16 and Epica DGX 32 Instruction Manual
Splash Screen Examples
Note: AMX reserves the right to add to the contents of the splash screen at any time, without notice.
Power-Up Splash Screen
The first example is of the splash screen that displays when power is applied to the enclosure. When
“Ready” appears, BCS commands can be entered for executing switches, verifying status, querying the
system for diagnostic information, etc.
Splash Screens Displaying System Information
Following are five examples of splash screen information from an Epica DGX 16 that could display
when different verbosity/component settings are specified. Depending on the amount of detail provided,
you may need to scroll to see the entire display.
The command in the first example, ~scrv3i1, can be used to check the host software (IOS) version
and the hardware driver (appcode) version.
FIG. 62 Power-up splash screen in HyperTerminal
FIG. 63 Display for v3i1 (verbosity 3, component 1)
[1:Enclosure] AMX AutoPatch Epica DGX 16 v1.0.1R
Ready
Firmware version
~scrv3i1!
[1:Enclosure] AutoPatch Epica DGX 16
[host software] v3.6.0
[hardware driver] v1.0.1 R
[build date] July 22 2010 11:29:26
[pld version] A1
[xnet address] 0x11029
[ap system id] 0x0
[nvram status] valid.. user preference restored
[nvram magic] 0xdedafaba
[sysrev id] 1