Instruction manual

Overview and General Specifications
10
Epica DGX 16 and Epica DGX 32 Instruction Manual
Front View
The enclosure, which is the structural basis of the Epica DGX 16 and 32 Distribution Matrices, can be
controlled using the standard front control panel, control software, or an external controller (for
additional information on control options, see page 15 and for control panel operation, see page 57). The
Power LED indicates the status of the power supplies.
Power LED on Front of Enclosure
The Power LED indicates the power status of the redundant power system within the
Epica DGX 16 and 32 enclosure as follows:
 Green – both power supplies are powered on
 Red – one of the power supplies is not receiving power or has failed
 Off – both power supplies are not receiving power
Rear View
The enclosure’s appearance, as viewed from the rear, will vary depending on the number and types of
input and output boards present. The Epica DGX 16 enclosure in FIG. 2 is fully loaded for 16x16
switching. The Epica DGX 32 enclosure in FIG. 3 is partially loaded for 28x28 switching.
Epica DGX 16
FIG. 1 Front view of an Epica DGX 32 enclosure
FIG. 2 Rear view of a full Epica DGX 16 enclosure
LCD Power IndicatorControl Dial
Control Keys
Output Keys
Input Keys
Input boards (up to 4) Output boards (up to 4)
Power supplies
Serial number
CPU/Control board
Note: Empty input or output
can be used to upgrade
numbered for expansion)
system.
board slots (which are