Instruction manual

Installation and Setup
22
Epica DGX 16 and Epica DGX 32 Instruction Manual
3. If applicable – For multiple-enclosure systems, link them according to the instructions provided
(see page 24).
Caution: On systems with SC fiber connectors, we recommend using the provided cable
management bars or some other type of cable management system to avoid damage to the fiber
cables.
4. Recommended for DGX SC Optical Boards – Attach the provided cable management bars to the
input and output boards (see page 23).
5. Attach only the first two source and destination devices (see page 35).
6. If applicable – Systems with DGX SC Optical Input and/or Output Boards require DGX Fiber
modules. Install the modules for the first two source and/or destination devices (see “System Setup
with DGX Modules” on page 49 and the module’s documentation).
7. Attach power cords to both power receptacles on each enclosure, then turn on the entire system
(see page 36).
We recommend using a surge protector and/or an AC line conditioner.
8. Execute a test switch to make sure the system is working properly (see page 40).
9. When the test switch works correctly, attach the remaining source and destination devices and any
additional DGX Fiber modules.
10. If applicable – Use the EDID Programmer.*
* EDID Programmer software can be used for re-programming the DGX DVI Input Boards if necessary
(see page 109). This software is located on the AMX AutoPatch CD (also available at www.amx.com).
Additional Setup
Additional setup tasks may include the following:.
 Establishing external control – See page 29.
 Establishing an NXB-AP-1000 connection (via the TCP/IP port) – See page 42.
 Setting the Control Panel password – See page 76 in the “Control Panel Operation” chapter.
 Defining local presets – See page 122 in “Appendix B – Managing Configuration Files.”
 Defining global presets – See page 65 in the “Control Panel Operation” chapter.