Instruction manual

Epica DGX SC Optical Boards
47
Epica DGX 16 and Epica DGX 32 Instruction Manual
Epica DGX SC Optical Boards
Applicability Notice
This chapter pertains to the following Epica DGX SC Optical Boards:
 FG1056-500 Input board
 FG1056-510 Output board
Epica DGX 16
Epica DGX 16 enclosures are built to hold up to eight DGX SC Optical Boards with four inputs or
outputs per board.
Each enclosure holds a maximum of four input and four output boards, accommodating connector
configurations up to a maximum of 16x16, as well as subsets (for example, 16x8 or 4x12).
Epica DGX 32
Epica DGX 32 enclosures are built to hold up to sixteen DGX SC Optical Boards with four inputs or
outputs per board.
Each enclosure holds a maximum of eight input and eight output boards, accommodating connector
configurations up to a maximum of 32x32, as well as subsets (for example, 12x24 or 32x8).
Routing Signals
DGX SC Optical Input Boards route signals to DGX SC Optical Output Boards or to any other type of
Epica DGX Output Boards. DGX SC Optical Output Boards accept signals from all types of
Epica DGX Boards. When routing signals between different board types, the Epica DGX 16 or 32
automatically converts the signal format to match the output board.
Currently, the following signals can be sent over DGX SC Optical Boards: DVI-D, analog video, and
digital or analog stereo audio. Supported analog video signals include RGBHV, RGBS, RGsB, and
Y/Pb/Pr.
DGX SC Optical Boards must be used in conjunction with DGX Fiber modules (see the compatibility
list on page 48 and the system setup information on page 49).
FIG. 30 Epica DGX SC Optical Boards, shown in an Epica DGX 32