Instruction manual

Epica DGX SC Optical Boards
48
Epica DGX 16 and Epica DGX 32 Instruction Manual
Specifications Epica DGX SC Optical Boards
Applies to input board FG1056-500 and output board FG1056-510.
Compatible AMX AutoPatch DGX Fiber modules:
 FG1010-200-01 – AVB-TX-DGX-HD15-SC Fiber
 FG1010-210-01 – AVB-TX-DGX-DVI-SC Fiber
 FG1010-400-01 – AVB-RX-DGX-SC Fiber-HD15
 FG1010-410-01 – AVB-RX-DGX-SC Fiber-DVI
Note: Either Transmitter (TX) module can be used in conjunction with either Receiver (RX) module.
* 480i and 576i are only available when being transmitted from a DGX HD-15 TX as a Y-Pb-Pr signal.
** 96 kHz audio is only available when the source video resolution is 800x600 @ 60 Hz (40 MHz pixel clock) or
greater. Otherwise 48 kHz is the maximum.
*** 3000 ft. cable requires 50/125 μm OM2 class low loss fiber cable.
Important: These boards are compatible only with other AMX AutoPatch products that support
the DGX single fiber technology. They are not
compatible with third-party optical distribution
amplifiers or multimode to single-mode converters.
AMX reserves the right to modify its products and their specifications without notice.
Epica DGX SC Optical Specifications
Parameter Value
Compatible AMX AutoPatch Fiber Products DGX HD-15 TX and RX, DGX DVI TX and RX,
other AMX AutoPatch DGX SC Fiber signal management
products
Signal Types over Fiber Video, audio, serial data
Video signal must be present to pass audio and serial data
Resolution Support 640x480 @ 60 Hz up to 1920x1200 @ 60 Hz
Interlaced Resolution Support 1080i 60, 59.94, 50 (fields per second)
576i 100, 50 (fields per second)*
480i 60 (fields per second)*
Audio Support Analog stereo or S/PDIF (S/PDIF up to 96 kHz sample rate**)
Serial Data Support Unidirectional RS-232, up to 115.2 k baud
Fiber Cable Type Multimode Simplex (with SC termination)
50/125 μm (preferred) or 62.5/125 μm
Fiber Cable Length Up to 3000 ft. (914.4 m) in with 50 μm cable***
Up to 3000 ft. (914.4 m) out with 50 μm cable***
Up to 1500 ft. (457.2 m) in with 62.5 μm cable
Up to 1500 ft. (457.2 m) out with 62.5 μm cable
Optical Budget 9.75 dBm (typical) between DGX TX and input board
9.75 dBm (typical) between output board and DGX RX
Optical Modulation Amplitude (OMA) Output: -6.25 dBm (typical)
Optical Modulation Amplitude (OMA) Input Sensitivity: -16.0 dBm
(typical)
Fiber Input Board Propagation Delay 1 μs
Fiber Output Board Propagation Delay 2 μs
Power Output of Laser Radiation (max.) 4.08 mW (SC optical output board)
Safety Certifications Class 1 Laser Product (Class 3R Laser Product when fiber is
disconnected from the unit) IEC 60825-1, 2001
(SC optical output board)
Fiber Connector SC optical