Instruction manual

Control Panel Operation
73
Epica DGX 16 and Epica DGX 32 Instruction Manual
Unlocking the Control Panel
When the panel is locked and you press any key, the Unlock Panel Screen appears. You have ten (10)
seconds to enter the password or the Control Panel remains locked. If you wait longer than 10 seconds,
press any key again before entering the password.
If you enter the wrong password while attempting to unlock the Control Panel, an invalid password
message appears and the Cancel Key flashes. Press the Cancel Key to clear the error and enter the
correct password.
To unlock the Control Panel:
1.
Press any key.
The Unlock Panel Screen appears (Input Keys 1 through 8 turn blue).
You must enter the password within ten (10) seconds.
2. Press the Input Keys in the following order: 1, 2, 3, 4, 5 (default password).
The panel unlocks and returns to the Function menu.
Setup Options
The following options are available under the Setup Options submenu:
 Software Version – to display software version information for the Control Panel
 Default VM – to change the factory default virtual matrix
 Reload Config – is not used in normal operations; use only when loading local presets to the
Control Panel or when directed to do so by technical support
 Change Password – to change the password from the factory default
Software Version
The Software Version Screen provides the following information:
 Driver – Control Panel’s firmware version
 Built – date the Control Panel’s software was built
 Host – software version of the initial operating system (IOS) for the Control Panel
 XNet ID – Control Panel’s XNNet device number
Use the following steps to check the software version information for the Epica DGX 16 or 32 Control
Panel.
To check the software version information:
1.
Press the Function Key.
The Function menu appears.