Instruction manual

NXB-AP-1000 Interface – Initial Setup by Network Admin
81
Epica DGX 16 and Epica DGX 32 Instruction Manual
Opening the NXB-AP-1000 Interface
Caution: We strongly recommend that the NXB-AP-1000 interface site be placed inside your
network firewall and that system security be turned on.
To open the NXB-AP-1000 interface:
1.
From the NetLinx Studio Zero-Config tab – Double-click on “NIB IP-Bridge Interface” or
right-click and select one of the launch browser options. (If the “NIB IP-Bridge Interface” is not
displayed, see the instructions on the previous page.)
The NXB-AP-1000 Home page opens (FIG. 41).
Or
In the address bar of your PC’s browser – Type the IP address and press Enter (to determine the
IP address, see the instructions on the previous page or contact your Network Administrator).
The PC must be on the same subnet (e.g., 192.168.X.X).
The NXB-AP-1000 Home page opens (FIG. 41).
2. Complete any necessary configuration of the NXB-AP-1000 interface. Instructions are included in
this chapter.
If the Home page does not open, see the “NXB-AP-1000 Troubleshooting” section on page 46.
FIG. 41 NXB-AP-1000 Home page shows system configuration information (Epica DGX 32 example)