Instruction manual

NXB-AP-1000 Interface – Initial Setup by Network Admin
82
Epica DGX 16 and Epica DGX 32 Instruction Manual
Navigating the NXB-AP-1000 Interface
The NXB-AP-1000 interface has two drop down menus: IP Control and Admin. These menus access all
the control, configuration, preferences, and settings pages in the interface. The menu options are shown
in FIG. 42 and FIG. 43. In addition, some pages have tab options as well (see FIG. 45 on page 84).
IP Control Menu - Options for the IP Control Pages in the Interface
Admin Menu - Options for the Configuration Manager Pages in the Interface
Getting a DHCP IP Address
By default, the NXB-AP-1000 interface is set to use a DHCP (Dynamic Host Configuration Protocol)
IP address (a connection must be established with a network that contains a DHCP server). If the
IP address has been changed to a static IP address and you want to change back to a DHCP IP address,
use the following directions.
To force invocation of a DHCP IP address:
1.
From the Admin drop down menu, select IP Settings.
2. If DHCP is not selected, click to enable.
3. Click Accept.
4. Click Reboot. The NXB-AP-1000 interface begins searching for a DHCP server.
If the search times out, the address will revert to the previous IP address.
Important: Any time you click “Reboot” from any page in the NXB-AP-1000 interface, the server
reboots. The reboot updates information between the Epica DGX 16 or 32 and the server.
(The Epica DGX 16 or 32 system itself does not reboot).
FIG. 42 IP Control drop down menu options
FIG. 43 Admin drop down menu options