Instruction manual

NXB-AP-1000 Interface – Initial Setup by Network Admin
92
Epica DGX 16 and Epica DGX 32 Instruction Manual
To disable DoD Security mode for an Epica DGX 16 or 32:
1.
Insert one end of an RJ-45 cable into a network card on a PC.
2. Insert the other end of the cable into the TCP/IP port on the enclosure.
3. Open an SSH terminal utility (e.g., Putty) and connect to the IP address of the NXB-AP-1000.
SSH utilities require a username and password to login (see “Important” note on previous page).
4. Type set security profile.
A prompt will appear indicating the current setting and the options for the setting.
5. To disable DoD Security mode, type 0 and press enter.
You will be prompted to reboot the system for the new setting to take effect.
6. Type reboot and press enter.
Important: When the system is taken out of DoD Security mode, the user name and password will
not
change back to their previous settings. They will remain as administrator and Amx1234!
or as whatever their values were changed to after the device was put into DoD Security mode.
three security profile
settings table